The
following features apply to both Viper machines, except where
stated:
DMX 512 as standard
The VIPER can be controlled via
DMX 512. The connection is done with 5pin-XLR-plugs.
The DMX start address can be adjusted and saved via the control
panel.
The machine can also be controlled
with analog (0 - 10 V) via a lighting desk or via XLR-remote
(option). This connection is done with 3pin-XLR-plugs.
A stand-alone-mode is also possible.
The adjustments are done directly at the machine. A short
press at the start button makes the machine run. Therefore
a permanent pressing of the start button is unnecessary.
Internal timer
With the internal timer the fog
time can be exactly adjusted in seconds, the wait time in
minutes and the output in %.
Control panel
The control panel with LED-display,
simple symbols allow for easy operation. It also protects
the control buttons against dirt.
Finest adjustments of the output
Digital technology makes fine adjustment
of the pump possible. In steps of 1% the output can be adjusted
from 0 - 99%. Thus, any desired effect from a tiny fog-cloud
to the thickest fog can be produced. This enables the VIPER
to be used in both small and large locations.
Connector for external fan -
Viper 2.6 only
An external fan with max. 800
Watt can be connected to the VIPER 2.6. Once connected to
the machine, the fan can also be adjusted via DMX. The machine
then uses two following channels at the desk.
Advantages
DMX as standard, analog and stand-alone-mode
Internal timer
Fog output adjustable in steps of 1% (0 - 99%)
Continuous output
Easy handling
Powerful output
Made in Germany
|
