For special effects, theatre, musicals and movies, models, props, magic and more!

The tiny dimensions and weight (just 380 grams) means this smoke machine can be easily built into backdrops, props etc.

The heart of the generator is a programmable microprocessor which controls fog production. You can program in a fixed fog amount directly at the machine. This programmed fog amount can easily be reproduced and/or changed.

Tiny FX System & Accessories
Tiny FX Battery Powered Smoke Machine System comprising Tiny FX Fogger, battery, charger, wired remote control, 6 x fluid tanks, refill set, 250ml fog fluid, lead and carry case	£735.00
Tiny FX Smoke Machine System comprising Tiny FX Fogger, mains power supply unit, wired remote control, 250ml fluid tank and adaptor, 1 metre fluid pipe, 250ml fog fluid, lead, power lead. **Note: NO battery, charger or carry case is supplied with this version - this is the mains powered kit that comes with the mains power adaptor instead**	£735.00
Tiny FX Smoke Machine System comprising Tiny FX Fogger, wired remote control, 250ml fluid tank and adaptor, 1 metre fluid pipe, 250ml fog fluid, battery cable to bare ends (no battery supplied). **Note: NO battery, charger or carry case is supplied with this version - you need to supply your own suitable 11.1v battery to power the unit**	£595.00
250ml Container Tiny Fog Fluid (fits into the foam case)	£11.00
2 Litre Container Tiny Fog Fluid	£48.00
Ducting adaptor for 15mm diameter hose	£28.00
15mm diameter Silicon hose (price per metre)	£10.00
Time-It Timer controller	£115.00
DMX-It DMX Interface	£118.00
Wireless remote control (transmitter and receiver)	£185.00
Y-splitter adaptor for silicon hose	£3.00
Spare battery for Tiny FX	£110.00
Spare battery charger for Tiny FX	£67.00
Spare Vaporiser for Tiny FX in protective case with full fitting instructions	£34.00
Suitable smoke fluid

Similar products:

The Pea Soup Micro Rocket is our best value battery powered unit.
Click on the image below to find out more:

Tiny S Smoke Generator

This unit is virtually the same as the Tiny FX unit above, except for the following differences:

• Battery can be screwed into the machine, making the whole system a one-piece unit.
• Lower volume smoke output - 30 watt heater instead of 75 watt.
• Dimensions are 10.3cm x 5.1cm x 3.4cm.
• Weight 250g with battery and fluid.
• Battery voltage is 3.7v. Two batteries are supplied with the system, each giving approx 10 mins smoke.
• Fluid consumption is 0.5ml per minute due to reduced output, so a 5ml fluid tank gives 10 mins smoke production in total.
• Please note: The wireless remote, DMX or timer controllers for the Tiny FX unit will NOT work with the Tiny S. There is a radio remote system available for the Tiny S unit only (see accessories below).

Package includes: Tiny S Fogger, 2 x 3.7v batteries, charger, wired remote control, 6 x 5ml fluid tanks, refill set, 250ml fog fluid, lead, carry case.

Each 5ml smoke fluid syringe (6 provided, plus refill kit) provides up to 4 minutes of smoke production.

Please note on all Tiny Foggers, the vaporiser PCB is not a warrantied item. It is a wearing part and not covered by the warranty.

Tiny S System & Accessories
Tiny S Fogger System Comprising fogger, 2 x 3.7v batteries, charger, wired remote control, 6 x 5ml fluid tanks, refill set, 250ml fog fluid, lead and carry case.	£660.00
Wireless remote control system (transmitter and receiver) for Tiny S only. 100m range in ideal conditions.	£185.00
Ducting adaptor for 15mm diameter hose	£28.00
15mm diameter Silicon hose (price per metre)	£10.00
Y-splitter adaptor for silicon hose	£3.00
250ml Container Tiny Fog Fluid (fits into the foam case)	£11.00
2 Litre Container Tiny Fog Fluid	£48.00
Spare Vaporiser for Tiny S in protective case with full fitting instructions	£34.00

The TINY CX is a handy, compact battery-driven fog generator. Its easy handling and quick start-up is outstanding. It is essentially the Tiny FX (above) contained in one hand-held unit for easier handling and more convenient one-handed operation.

With its warming up time of less than a second, its light weight (630g) and small dimensions (L = 25 x W = 5.3 x H = 5.5 cm), this machine is applicable in many fields of operation.

For theatre, film, TV and photographers, musicals and special effects, air flow and air tightness testing – everywhere where fog is needed quickly and unobtrusively, the Tiny CX is the perfect alternative to normal mains powered fog machines.

Operation

To put the Tiny CX into operation:
The fluid tank, which is fitted to the case, has to be filled with fluid.
The supplied 12V-battery has to be inserted into the case. It engages itself.
Now the machine is ready to use. It can be started immediately and continuously without any warming up time.

With one battery you can produce up to 12 minutes of continuous output or up to 150 puffs of 5 sec.
When the battery is flat, you can quickly change it for a spare (optional) and so continue operation.

The unit can easily be triggered with one hand. The start button is placed on the comfortable grip and can be pressed with the thumb.

A special fluid ensures that dense fog is produced with the lowest of fluid consumption.

The vaporiser can be easily changed by the user on site.

The unit can be controlled in the following ways:
With a DMX-converter the machine can be triggered via DMX 512. With a Timer you can program in the fog time and interval period.
It can also be triggered with a radio remote control.

• Small dimensions, light weight
• Battery supplies energy only when necessary
• Warm up time less than 1 second
• Continuous output
• Lowest fluid consumption
• Easy handling
• Triggered with the start button or the optional radio remote, DMX-converter and timer

Power requirement: 70 Watt
Voltage: 11.1 V battery
Warm up time: 0.5 sec.
Fluid tank capacity: 50 ml
Fluid consumption: 2.3 ml/min.
Continuous output with battery: 15 min

Control: start button / radio remote (optional) / DMX512 (optional) / Timer (optional)
Dimensions (L x W x H) 25 x 5.3 x 5.5 cm
Weight incl. battery 630 g

Package includes: Tiny Compact (fog generator + battery pack), charger, 250ml fluid, carry case.

Please note on all Tiny Foggers, the vaporiser PCB is not a warrantied item. It is a wearing part and not covered by the warranty.

Tiny CX System & Accessories
Tiny CX Battery Powered Smoke Machine System Comprising fog generator, battery, charger, 250ml fluid and carry case	£695.00
250ml Container Tiny Fog Fluid (fits into the foam case)	£11.00
2 Litre Container Tiny Fog Fluid	£48.00
Ducting adaptor for 15mm diameter hose	£28.00
15mm diameter Silicon hose (price per metre)	£10.00
Wireless remote control system (transmitter and receiver) for Tiny CX.	£185.00
Time-It Timer controller	£115.00
DMX-It DMX Interface	£118.00
Y-splitter adaptor for silicon hose	£3.00
Spare Battery pack for Tiny CX	£114.00
Spare battery charger for Tiny CX	£67.00
Spare Vaporiser for Tiny CX in protective case with full fitting instructions	£34.00

Ideal for theatre, film, TV and photographers, musicals and special effects - everywhere where fog is needed quickly and efficiently, this unit is the perfect alternative to normal mains powered fog generators.

• Very short 1 second heat-up time

• Light weight (5.6 kg) and small dimensions (L=22.3, W=10, H=21 cm)

• Adjustable smoke output

• 250 hours stand-by time

The battery supplies energy only when necessary, so the operation time is considerably increased - the stand-by time is 250 hours.

With one battery 10 minutes of continuous output or up to 150 x 5 second bursts can be produced. When the battery is flat it has to be recharged with the supplied charger.
As an option a spare battery pack is available (battery complete with housing, PCB, fuses and plug). The fog generator can easily be disconnected from the battery and connected to the new battery quickly. Alternatively, an external battery connector cable is available allowing you to connect a 12v car battery, giving up to 2 hours of smoke production in total!

• Minimal fluid consumption - just 10ml per minute

The unit is equipped with a 3 pin-XLR-socket for analog (0 - 10V) control. An XLR-remote as well as a wireless radio remote can be connected (both optional extras).

With the optional DMX-converter (DMXit) the machine can be controlled via DMX 512.

With the optional Timer module a 'fog' and 'wait' time can be programmed in.
 

• Portable use
• Heat-up time only 1 second
• Light weight, small dimensions
• Adjustable output
• 250 hours stand-by time
• Continuous output
• Easy handling
• Control via start button or analog (0 - 12V) and with optional controllers: XLR-remote, radio remote, DMX-converter, Timer
• Minimal fluid consumption
• Easy change of the battery pack

• Fog generator
• Battery pack
• Battery charger
• Fluid tank 250 ml

Power: 400 Watt
Voltage: 12 V with battery
Warm up time: 1 second
Fluid consumption at continuous output: 10 ml/min.
Fluid tank capacity: 250 ml
Fog output: adjustable
Fog time: with battery
10 min. continuous output or 150 x 5 sec. bursts
Control: Start button on hondle / 0 – 10 V analogue
OPTIONAL: Radio remote / DMX 512 / Timer

Temperature control: Microprocessor controlled
Dimensions (L x W x H): 22.3 x 10 x 21 cm
Weight incl. battery: 5.6 kg

We ship worldwide
UK, EU or US plug supplied for charger